Initial D World - Discussion Board / Forums
   
Welcome Guest ( Log In | Register )Resend Validation Email

DJ Panel ( Server Stats )   Song History   Initial D World Chat Room (Discord)   Broadband Stream
RADIO BROADCAST » streaming at 96kbps with 5 unique listeners, playing Starlet - You're Gonna Be

       

 

Views: 6,982  ·  Replies: 6 
> Odd idling after cleaning throttle body
RalliKai
  Posted: Sep 21 2015, 10:18 AM


IDW Goldmember
**********

Group: Advanced Members
Posts: 2,164
Member No.: 3,607
Joined: Oct 9th 2004
Location: Update Profile





Recently I started having problems with my engine stalling immediately following a cold start. After some research, I found that a dirty throttle body was the likely culprit. Went about cleaning it yesterday; started it and the car cranked fine again. cool.gif

Driving it around today I noticed some strange RPM dips in 5th gear when coasting downhill and when slowing down, a subtle push in the engine as it downshifted into 1st. Nothing severe but definitely noticeable. After cleaning the throttle body, I put the car in the engine on position without starting it for 60 seconds initially to reset the computer. Not sure if I really reset the computer to factory settings.
Nomake Wan
Posted: Sep 21 2015, 03:29 PM


ShiMACHaze
**********

Group: Advanced Members
Posts: 19,542
Member No.: 5,394
Joined: Feb 5th 2005
Location: Drydock





Without knowing the car it's hard to say. However, generally resetting a computer is done by disconnecting the battery and letting the car sit, for instance with the door open. Once all residual power is drained and the volatile memory is reset, done.

[ Post made via Mobile Device ]
Proud Contributor of IDW Forums and the Music Section Revival Project
RalliKai
  Posted: Sep 21 2015, 04:04 PM


IDW Goldmember
**********

Group: Advanced Members
Posts: 2,164
Member No.: 3,607
Joined: Oct 9th 2004
Location: Update Profile





An 08' Mazda 3 with the 2.3L.

I was doing some additional reading and found that disconnecting the battery for 10-15 minutes would reset the computer codes. Additionally, some noted that you also idle the engine for 20 minutes so the ECU learns the proper idle range after resetting it but that was being advised for new batteries.
Nomake Wan
Posted: Sep 21 2015, 05:27 PM


ShiMACHaze
**********

Group: Advanced Members
Posts: 19,542
Member No.: 5,394
Joined: Feb 5th 2005
Location: Drydock





New batteries that could conceivably take 10-15 minutes to swap. Meaning the computer is reset. Sounds like something you should try. wink2.gif

[ Post made via Mobile Device ]
Proud Contributor of IDW Forums and the Music Section Revival Project
The Sixth Element
Posted: Sep 21 2015, 06:48 PM


matter intangible
**********

Group: Members
Posts: 394
Member No.: 44,779
Joined: Sep 28th 2014
Location: Los Angeles, CA





QUOTE (RalliKai @ 8 hours, 30 minutes ago)
Recently I started having problems with my engine stalling immediately following a cold start. After some research, I found that a dirty throttle body was the likely culprit. Went about cleaning it yesterday; started it and the car cranked fine again. cool.gif

Driving it around today I noticed some strange RPM dips in 5th gear when coasting downhill and when slowing down, a subtle push in the engine as it downshifted into 1st. Nothing severe but definitely noticeable. After cleaning the throttle body, I put the car in the engine on position without starting it for 60 seconds initially to reset the computer. Not sure if I really reset the computer to factory settings.

Have you check the Fuel Pressure in the engine? I'm taking a technician class and I find that when the idle or RPM isn't normal its either the compression or fuel pressure that might be the cause. Have a technician do a diagnosis on your Mazda or DIY with a scanner to see what might be the problem. Hope I could help you my man. smile.gif
RalliKai
  Posted: Sep 22 2015, 03:27 PM


IDW Goldmember
**********

Group: Advanced Members
Posts: 2,164
Member No.: 3,607
Joined: Oct 9th 2004
Location: Update Profile





Yep, properly resetting the computer seems to have fixed the unstable idling. Thanks for the input.
Nomake Wan
Posted: Sep 22 2015, 05:30 PM


ShiMACHaze
**********

Group: Advanced Members
Posts: 19,542
Member No.: 5,394
Joined: Feb 5th 2005
Location: Drydock





Glad to hear it. smile.gif

[ Post made via Mobile Device ]
Proud Contributor of IDW Forums and the Music Section Revival Project